Icom IC-7200 Transceiver - Yazdırılabilir Versiyon +- YM7KA Forum (http://ym7ka.com/forum) +-- Forum: YM7KA TRAC Trabzon Şubesi Forumları (/forumdisplay.php?fid=1) +--- Forum: Telsiz Tanıtımları (/forumdisplay.php?fid=11) +--- Konu: Icom IC-7200 Transceiver (/showthread.php?tid=74) |
Icom IC-7200 Transceiver - TA7X - 06-12-2008 05:26 PM The ICOM IC-7200 is a robustly built amateur transceiver providing coverage of HF amateur bands plus 6 meters. Power is 100 watts. Features include easy-to-use controls DSP filtering with 51 passband widths digital twin passband tuning manual notch filter keypad entry dual VFOs large display voice synthesizer 201 memories 20 dB attenuator preamp 6 kHz roofing filter RIT scanning 1 Hz step tuning and more! The excellent general coverage receiver tunes from 30 kHz to 60 MHz. The meter displays Power/SWR/ALC. Power is 2 to 100 watts (40W AM). Although the IC-7200 is not waterproof extra design steps have been applied to the front panel buttons and knobs. This provides a measure of protection against water intrusion. There is even a USB port on the rear panel! This radio comes with an HM-36 hand mic OPC-1457 DC power cord and spare fuses. General * Frequency Range: o RX 0.030-29.999999 MHz (guaranteed range: 0.5-29.999999 MHz) o TX 1.800-1.999999 MHz 3.500-3.999999 MHz (varies with version) o 5.3305 5.3465 5.3665 5.3715 5.4035 *2 o 7.000-7.300000 MHz 10.100-10.150000 MHz o 14.000-14.350000 MHz 18.068-18.168000 MHz o 21.000-21.450000 MHz 24.890-24.990000 MHz o 28.000-29.700000 MHz 50.000-54.000000 MHz * Mode: USB LSB CW RTTY (FSK) AM * No. of memory channels: 201 (199 regular 2 scan edges) * Frequency resolution: 1 Hz * Frequency stability: Less than ±0.5 ppm. * Power supply requirement: 13.8 V DC ±15% (negative ground) * Current drain (at 13.8 V DC): o Receive: stand-by 1.3 A ; max audio 2.0 A o Transmit: max. power 22.0 A * Usable temperature range: -10°C to +60°C (+14F to+140F) * Antenna connector: SO-239 (50 ohm) * Dimensions: 240mm (W) x 95mm (H) x 239mm (D) * (projections not included) 9 7/16in (W) x 3 3/4in (H) x 11 1/16in (D) * Weight: 5.5 kg; 12.1 lb * ACC connector: 13-pin * REMOTE connector: 2-conductor 3.5 (d) mm; (1/8") Transmitter * Modulation system: o SSB: Digital PSN modulation o AM: digital low power modulation * Output power: o SSB CW RTTY: 2-100W o AM: 1-40W * Spurious emissions: Less than -50 dB below peak output power * spurious freq.; below 30 MHz: -50dB above 30 MHz: -63dB * Carrier suppression: More than 50 dB * Unwanted sideband: More than 50 dB * Microphone connector: 8-pin connector (600 ohm) * KEY connector: 3 conductor 6.5 (d) mm (1/4") * SEND connector: Phono (RCA) * ALC connector: Phono (RCA) Receiver * Receiver system: Triple-conversion superheterodyne * Sensitivity: (10 dB S/N) o SSB CW RTTY: 0.16 µV (1.8-29.999999 MHz) o AM: 13 µV (0.5-1.799999 MHz) o AM: 2 µV (1.8-29.999999 MHz) * SQL sensitivity: Less than 5.6 µV (SSB) * Selectivity: o SSB CW RTTY: More than 2.4 kHz/-6 dB o Less than 3.6 kHz/-60 dB o AM: More than 6.0 kHz/-6 dB o Less than 16 kHz/-60 dB * Spurious and image rejection ratio: More than 70 dB (1.8-29.999999 MHz) * Audio output power: More than 2.0 W at 10% distortion with at 8 ohm load (at 13.8 V DC) * RIT variable range: ±9.9 kHz * PHONES connector: 3-conductor 6.5 (d) mm (1/4") * EXT SP connector: 2-conductor 3.5 (d) mm (1/8") 8 ohms * Specifications are subject to change without notice or obligation. |