Hello World!
This is a sample MyBB Plugin (which can be disabled!) that displays this message on all pages.


Mesaj Önizleme  Konuyu Gönder 
Icom IC-7200 Transceiver
Yazar Mesaj
TA7X
Kayıtsız


Mesaj: #1
Icom IC-7200 Transceiver


The ICOM IC-7200 is a robustly built amateur transceiver providing coverage of HF amateur bands plus 6 meters. Power is 100 watts. Features include easy-to-use controls DSP filtering with 51 passband widths digital twin passband tuning manual notch filter keypad entry dual VFOs large display voice synthesizer 201 memories 20 dB attenuator preamp 6 kHz roofing filter RIT scanning 1 Hz step tuning and more! The excellent general coverage receiver tunes from 30 kHz to 60 MHz. The meter displays Power/SWR/ALC. Power is 2 to 100 watts (40W AM).
Although the IC-7200 is not waterproof extra design steps have been applied to the front panel buttons and knobs. This provides a measure of protection against water intrusion. There is even a USB port on the rear panel! This radio comes with an HM-36 hand mic OPC-1457 DC power cord and spare fuses.

General

* Frequency Range:
o RX 0.030-29.999999 MHz (guaranteed range: 0.5-29.999999 MHz)
o TX 1.800-1.999999 MHz 3.500-3.999999 MHz (varies with version)
o 5.3305 5.3465 5.3665 5.3715 5.4035 *2
o 7.000-7.300000 MHz 10.100-10.150000 MHz
o 14.000-14.350000 MHz 18.068-18.168000 MHz
o 21.000-21.450000 MHz 24.890-24.990000 MHz
o 28.000-29.700000 MHz 50.000-54.000000 MHz
* Mode: USB LSB CW RTTY (FSK) AM
* No. of memory channels: 201 (199 regular 2 scan edges)
* Frequency resolution: 1 Hz
* Frequency stability: Less than ±0.5 ppm.
* Power supply requirement: 13.8 V DC ±15% (negative ground)
* Current drain (at 13.8 V DC):
o Receive: stand-by 1.3 A ; max audio 2.0 A
o Transmit: max. power 22.0 A
* Usable temperature range: -10°C to +60°C (+14F to+140F)
* Antenna connector: SO-239 (50 ohm)
* Dimensions: 240mm (W) x 95mm (H) x 239mm (D)
* (projections not included) 9 7/16in (W) x 3 3/4in (H) x 11 1/16in (D)
* Weight: 5.5 kg; 12.1 lb
* ACC connector: 13-pin
* REMOTE connector: 2-conductor 3.5 (d) mm; (1/8")


Transmitter

* Modulation system:
o SSB: Digital PSN modulation
o AM: digital low power modulation
* Output power:
o SSB CW RTTY: 2-100W
o AM: 1-40W
* Spurious emissions: Less than -50 dB below peak output power
* spurious freq.; below 30 MHz: -50dB above 30 MHz: -63dB
* Carrier suppression: More than 50 dB
* Unwanted sideband: More than 50 dB
* Microphone connector: 8-pin connector (600 ohm)
* KEY connector: 3 conductor 6.5 (d) mm (1/4")
* SEND connector: Phono (RCA)
* ALC connector: Phono (RCA)


Receiver

* Receiver system: Triple-conversion superheterodyne
* Sensitivity: (10 dB S/N)
o SSB CW RTTY: 0.16 µV (1.8-29.999999 MHz)
o AM: 13 µV (0.5-1.799999 MHz)
o AM: 2 µV (1.8-29.999999 MHz)
* SQL sensitivity: Less than 5.6 µV (SSB)
* Selectivity:
o SSB CW RTTY: More than 2.4 kHz/-6 dB
o Less than 3.6 kHz/-60 dB
o AM: More than 6.0 kHz/-6 dB
o Less than 16 kHz/-60 dB
* Spurious and image rejection ratio: More than 70 dB (1.8-29.999999 MHz)
* Audio output power: More than 2.0 W at 10% distortion with at 8 ohm load (at 13.8 V DC)
* RIT variable range: ±9.9 kHz
* PHONES connector: 3-conductor 6.5 (d) mm (1/4")
* EXT SP connector: 2-conductor 3.5 (d) mm (1/8") 8 ohms
* Specifications are subject to change without notice or obligation.

06-12-2008 05:26 PM
Bu mesajı bir cevapta alıntı yap
Mesaj Önizleme  Konuyu Gönder 

Yazdırılabilir Bir Versiyona Bak
Bu Konuyu Bir Arkadaşına Gönder
Bu Konuya Abone Ol | Konuyu Favorilerine Ekle

Foruma Git: